Not lit = printer deselected (cannot receive data)Ģ QUIET: Glows = printer is in Quiet state.ģ HSD / UTL / NLQ / SSD: Indicate print quality selected. All the information provided is subject to change from time to time at the sole discretion of Oki Data.1 SEL: Glows = printer selected, ready to receive data However, Oki Data assumes no responsibility for errors or omissions which may occur. Oki Data has taken care to insure that the information is complete, accurate and up-to-date. The first line prints at the red line of the plastic paper shield (7) on the printhead.Ĥ Keep holding SHIFT and press QUIET/TOF a few times to set the Top of Form.ĥ When Top of Form is at the correct position, release all keys.Ħ Press SEL/MENU to place the printer on line.įor information on resetting the Top of Form to the factory default, refer to 'Using Your Printer, Top of Form, Reset Top of Form to Factory Default.' Press FF/LOAD / Micro Feed Up to increase the space (move Top of Form lower). Press LF / Micro Feed Down to decrease the space (move Top of Form higher). Then, press LF / Micro Feed Down (2) or FF/LOAD / Micro Feed Up (3), depending on which direction you want to move the paper to align the tear-off position.

Refer to 'Using Your Printer, Top of Form, Forms Tear-Off Status (ON or OFF).'Ģ Press SEL/MENU (6) to take the printer off line. If you turn the platen knob when the printer is turned on, you will cause the Top of Form to misalign Always turn the printer off before turning the platen knob!Īlways determine the status of the Forms Tear-Off menu setting BEFORE setting the Top of Form.

Setting Top of Form, Forms Tear-Off ON (Step B)

Oki microline 320 turbo manual